BierBot Bricks Forum

Reinstalled raspian and bierbot. Now showing 00-800000000000 in the 1 wire folder. Found out gpio17 was the 1 wire pin. Slowly getting there. Need to check all connections now

It can't even see the probes in script so I'm going to wipe my SD card. Reinstall raspian and start again. Would my existing API still work?

I have been reading online ( dangerous I know). Do I need to install any extra script for 1 wire even though it is switched on in preferences? Or is it all in the bierbot software?

Interesting that you use 3.3v on the pi but 5v on the Arduino to run a ds18b20

Ok so probe number 4 is no different. Still not showing

Yeah still no luck. I'll wait till my new probe turns up and try again. Used both 3.3v outputs and different grounds but no reading

I've tried 3 different probes and none appear when I try to set up my biab profile. Gpio inside is enabled on my pi. Ordered another probe just to be sure. Any ideas?

All sorted out now. It seemed to take nearly an hour to show up as a brick on the dashboard.
Another question. Can I add my temp sensors as I'm setting it up at work and my brewery is at home

Good afternoon. I'm confused. After my Arduino system went bang I decided to give this a go on a pi. Do I have to have the sonoff? Watching the video on YouTube there is no sonoff and the wiring diagram doesn't show one, but I can't configure my pi as it says no brick connected. Do I have to have a ...