iSpindle does not record historic gravity

[Flemming]

Hello

I started experience problems like metioned in subject.

The first fermentation recorded fine. But now something have changed and i can not figure out what

Temperature from iSpindle is recorded fine but not a single gravity datapoint shows up

[Bernhard]

Are you in manual or automatic mode?

[Flemming]

Automatic mode.

IMG_8035.png (92.33 KiB) Viewed 29575 times

IMG_8036.png (163.95 KiB) Viewed 29573 times

IMG_8036.png (163.95 KiB) Viewed 29573 times

[Bernhard]

Invalid values are automatically filtered out. I currently don't have my laptop with me, but I'm pretty sure 29°P is considered invalid.

Calibrating the angle to gravity values should fix it.

Cheers,
Bernhard.

[Flemming]

The values in the screenshots cannot be trusted. I have juggled so much around with the settings, i pure desperation, that most of them are unreliablel.

My iSpindle is calibrated - using high sugar solution and diluting it slowly while recording tilt angle to get the correct calibartion values into the iSpndle Firmware.

Like I mentioned in first post - Everything WORKED flawlesly for my FIRST brew... now - a few weeks later - gravity is not recorded and no graph is showing.

I suspect it have something to do with recipy maybe... and/or relation between https://bricks.bierbot.com/#/settings/interface and https://bricks.bierbot.com/#/brewery/bricks Settings . . .

I have also tried to use "Overwrite polynom to calculate gravity" using values from ducumentation(I know they do not fit 100%) just for test but it do not change that no datapoints are recorded in gravity history graph.

[Flemming]

I just found that i can not enter gravity in log manually either?

This is really puzzleing me

ScreenShot 2023-10-16 082455.png (76.41 KiB) Viewed 29559 times

The popup shows up and i can input numbers and click Add - then a short animation shows up briefly but no datapoint is added anywhere as far as I can see...

[Flemming]

The website started recording gravity datapoints yesterday - I do not know why, but needed to let you know

IMG_8038.png (239.69 KiB) Viewed 29556 times

[GAS]

Have the same problem with my new ispindel, all parameters are in normal limits, readings a stable evry 15min, no historycal graphics, just a point of curent temp and gravity in "manual" mode.